Autore Topic: how to make an hamon  (Letto 4072 volte)

0 Utenti e 1 Visitatore stanno visualizzando questo topic.

kenpachi zarachi

  • Visitatore
how to make an hamon
« il: 12 Luglio 2013, 10:00:55 am »
Here the link to the italian version :
http://www.bik-lab.com/tutorials/tutorial-per-un-hamon/

You have to bevel a blade leaving a thickness at around 1,5 mm . the blade was finshed now with 120 coarse paper .
Now you have to draw the shape of the blade on a see-through sheet .

on which you have to mark the hamon line

Cut from the sheet the line of the hamon and use it for making both the side of the blade .
The mentioned step is quite important in order to have symmetrical hamon line


No we start :

the right compactness




Let it dry for at least 24 hours
Now it's time to temper the blade ( I am using a gas forge ) .
Heat the blade to the right temperature , then quench it in water for about 3-4 seconds , then immediately finish to quench it in oil






Pictures are scrap , here below the video
https://www.youtube.com/watch?v=LaPIEinT9_o&list=UU0PWcMT4Kf_-o9W_5g0V34Q&index=1
Brush away satanite

then in the oven for tempering

Let the blade getting cold and then start removing the oxide layer with 60 grit belt and then continue polishing
grit 60

120, then 240

up to 600

800 ,1000

soldering the guard


After perfectly degreasing the blade , sink it for 4-5 mins in a moisture made up of 1 part of ferric chloride and 5 part of water

Remove the oxyde left by the chloride washing the blade with soap and water

Repeat this step three times ( chloride-washing) in order to let the chloride going deeper in the steel

Now sink the blade in water mixed with baking soda to quit the effects of the chloride

cover the blade with a lot of oil , pack it in paper and let it rest night time


then I start to roughly polishing the blade with a cotton wheel and some green polishing paste .
Then by hand wit kleenex and etilic alcohol Icontinue cleaning the blade , paying attention to use a clean piece of paer as soon as it becomes dirty


..... continue polishing with bodyshop paste and a wool cloth


have a look at the different porosity of betwwen the harder part and the softer part of the blade


The blade before the bodyshop polishing paste

After the polishing paste

Blade is now finished

« Ultima modifica: 12 Luglio 2013, 12:19:06 pm da kenpachi zarachi »